Profiling Dual Monitors W10
I run two monitors - my main one an Eizo SX2462, & a secondary one a Samsung 2433 both 1920x1200 with my desktop set to "extend these displays" I calibrate my monitors with a Spyder 3 Elite
After updating to W10, when I run spyder profile chooser, with "only profiles already associated with this monitor checked", I get a list of all the created profile for my Eizo monitor but none for my Samsung.
If I check "all monitor profiles" I can see my Samsung profiles but when I select one, I get a message
SetDefaultProfile.GetMonitorStrings failed [00010003] Error 1248 (CMSSupport.cpp 386) Clicking Ok brings up the message String Resource 1959781750
I've also tried re-running the spyder profiling software, & I no longer get a message to select which monitor I wish to calibrate - I can only calibrate the Eizo
When I look in device manager, under monitors the Eizo shows by name but the Samsung shows as PnP Monitor (standard). I've tried updating the driver but it says that the best one is installed
Any Ideas?
|